The road sector in Botswana continues to develop its road network throughout the country at a tremendous rate. When Botswana gained independence in 1966, it had only 10 km (16 mi) of bitumen road. By 1992 the total length of bituminous surfaced road reached 3500 km (2,175 mi) out of a total road network of 18,000 km (11,285 mi). These statistics clearly show that the majority of roads are not yet surfaced; these are low-volume roads that provide access to the rural areas where most of the country's population is found, though in low density. In spite of the rapid improvement in the quality of the national road network in recent years, much remains to be done. In the early 1970s and early 1980s the rural roads unit was introduced in the Ministry of Works Transport and Communications, which was charged with the responsibility of design and construction of low-volume roads around the country in a bid to integrate the country's road network. This unit was later disbanded in the 1990s, and all roads are improved through the conventional procurement system using private contractors. For these roads the justification of a surfacing project based on conventional economic return methods does not apply, and worse still, the road improvements have to compete with other amenities for the same limited resources. Three ministries in Botswana are responsible for roads: Ministry of Works Transport and Communications, Ministry of Local Government, and Ministry of Trade, Industry, Wildlife and Tourism. These ministries have different responsibilities for different roads within the country, and earth, sand, and gravel roads are found under the jurisdiction of each of the ministries. The major drawbacks concerning low-volume roads in Botswana are inadequate maintenance, poor road construction materials, and the environmental impacts of the roads. Since the budget and resources are inadequate to keep these roads in good condition, it would be prudent to find technological means that would improve the locally available road construction materials so as to minimize their effects on the environment and vehicle operating costs. This paper is also available on CD-ROM (see C 30152 CD-ROM).
Abstract