Simple performance tests (SPTs) to be used with the Superpave volumetric mixture design procedure were recently recommended by NCHRP Project 9-19 (Simple Performance Test for Superpave Mix Design). Field validation of the SPTs is critical to their final acceptance and implementation in Superpave mixture design practice. Special Pavement Studies-1 (SPS-1) prematurely rutted sections on US-281 in Texas were used to validate the SPTs for permanent deformation, including the dynamic modulus test and repeated-load test and associated rutting indicators E*/sin delta and flow number (Fn), respectively. The results of this case study clearly show that both the dynamic modulus test and E*/sin delta and the repeated-load test and Fn can effectively distinguish the good mixtures from the bad. Compared with E*/sin delta, Fn can better differentiate the performance of asphalt mixtures. These results preliminarily validated both SPTs for permanent deformation. In addition, the location of the tertiary point in the plot of permanent strain versus number of load repetitions is clarified; a simple linear model needs to be added in order to determine the Fn. Furthermore, the possibility of using the number of load repetitions (Nps) corresponding to the initial point of the secondary stage to characterize the rutting resistance of asphalt mixtures is discussed. The new indicator proposed is supported by the limited data presented in this paper and can be easily determined and can reduce test duration significantly.
Samenvatting